Got this Amiga 500 Revision 5 computer in a non working state. Initial problem was a black screen. Upon reseating the AGNUS chip, the machine showed a green screen. Green screen usually means bad RAM, first thing I tried was to burn an EPROM with DIAGROM and fit it in the ROM socket with an adapter for revision 5 motherboards. DIAGROM was unable to show me something on screen via the RGB video output, so I connected another computer to the AMIGA with a serial cable. With this method the output of DIAGROM was that the chip RAM was bad, the problem is that we still need to identify which ones are the bad ones, there are 16 RAM chips soldered to the pcb.
1702 Monitor had picture but no color.
First thing to check was that the Commodore 64 computer itself wasn’t the culprit, so I swapped it for another video source and the problem continued. I’ve noticed that touching the switch in the back that selects between FRONT and REAR inputs had some effect and the color was present for a brief moment, but then it fade away leaving just a black and white screen. Both REAR and FRONT inputs had the same issue.
Got this A1200 that was working fine except for some random crashes. Upon performing the Amiga Test Kit, it showed a fault in a CIA timer. The 1200 has smd components, that means you need a hot air station to remove some chips. The following pictures shows the removing process of U7. Then I added a PLCC socket for the new CIA ic. Machine fixed.
I got this TK95 machine in a non working state. If you don’t know the TK95 is a computer clone made in Brazil of the famous Sinclair Spectrum computer.
Mouse directions didn’t work on the Amiga 2000. The mouse was fine as it was tested on another machine. Another mouse was plugged in the Amiga 2000 and it didn’t work either.